IBM 8479 Hardware Maintenance Manual - Page 63
Settings, Attention
UPC - 087944653912
View all IBM 8479 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
memory. See the ServerProven list at http://www.ibm.com/pc/compat for a list of memory modules for use with the server. v Installing or removing DIMMs changes the configuration information in the server. Therefore, after installing or removing a DIMM, you must change and save the new configuration information by using the Configuration/Setup Utility program. When you restart the server, the system displays a message indicating that the memory configuration has changed. Start the Configuration/Setup Utility program and select Save Settings. See "Configuration" on page 25 for more information v The illustrations in this document might differ slightly from your hardware. DIMM connector 1 DIMM connector 2 DIMM connector 3 Retaining clip Complete the following steps to install a DIMM. Attention: When you handle static-sensitive devices, take precautions to avoid damage from static electricity. For details on handling these devices, see "Handling electrostatic discharge-sensitive devices" on page 106. 1. Review the safety precautions in Statement 1 and Statement 5 in "Safety notices (multi-lingual translations)" on page 107. 2. Turn off the server and peripheral devices and disconnect all external cables and power cords; then, remove the cover (see "Side cover removal" on page 42 for details). 3. Remove the support-bracket assembly and disconnect the fan cable from the connector (SYSFA1) on the system board. See "Removing the support bracket assembly" on page 45 for details. See "System board internal cable connectors" on page 38 for the location of the fan cable connector. 4. Install the DIMM: a. If you are installing a DIMM in connector 1, remove the AGP video adapter. Installing options 55