IBM 887022X Installation Guide - Page 38
Installing, adapter
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Installing an adapter The following notes describe the types of adapters that your server supports and other information that you must consider when installing an adapter: v The following illustration shows the location and bus speeds of the PCI-X expansion slots. Note: The illustrations in this document might differ slightly from your hardware. PCI-X slot 4 (100 MHz) PCI-X slot 5 (133 MHz) PCI-X slot 3 (100 MHz) PCI-X slot 2 (66 MHz) PCI-X slot 6 (133 MHz) Attention LED Power LED PCI-X slot 1 (66 MHz) Figure 23. PCI-X slot bus speeds and locations v Your server supports six hot-plug 64-bit adapters in the expansion slots located on the PCI-X board. Note: You can add up to 12 PCI-X slots to your server by connecting your server to an RXE-100 enclosure. For more information about the expansion enclosure, see the documentation that comes with your expansion enclosure. v Locate the documentation that comes with the adapter and follow those instructions in addition to the instructions in this chapter. v If you need to change the switch settings or jumper settings on your adapter, follow the instructions that come with the adapter. v Video adapters are not supported. v Some long adapters have extension handles or brackets installed. Before installing the adapter, you must remove the extension handle or bracket. v Your server uses a rotational interrupt technique to configure PCI-X adapters. You can use this technique to install PCI-X adapters that currently do not support sharing of PCI-X interrupts. 26 xSeries 445 Type 8870: Installation Guide