IBM 887022X Installation Guide - Page 48
Expansion, cabling, server, Modules
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
SMP Expansion Port cabling for one server with two SMP Expansion Modules: Complete the following steps to cable two SMP Expansion Modules in a single server together, using the two 25.4 cm (10 in.) SMP Expansion cables, for up to 8-way operation. In the illustration, the SMP Expansion Modules are numbered 0 and 1, from bottom to top. The SMP Expansion Ports are numbered 1 through 3, left to right. If your server comes with two SMP Expansion Modules, the SMP Expansion cables are included with the server. If you purchased a second SMP Expansion Module, the cables are included with the option. 11 2 3 0 1 2 3 Figure 33. SMP Expansion Module numbering 1. Remove the protective covers from the connectors on the ends of the cables. Protective cover Figure 34. SMP Expansion cable with protective cover 2. Connect one end of a 25.4 cm (10 in.) SMP Expansion cable to port 1 of SMP Expansion Module 0; then, connect the opposite end of the cable to port 1 of SMP Expansion Module 1. 3. Connect one end of the second 25.4 cm (10 in.) SMP Expansion cable to port 2 of SMP Expansion Module 0; then, connect the opposite end of the cable to port 2 of SMP Expansion Module 1. 4. If you are connecting an RXE-100 enclosure, go to "RXE Expansion Port cabling for one server with two SMP Expansion Modules" on page 43. If you are not connecting an RXE-100 enclosure, connect all remaining external cables to the server; then, go to "Creating a scalable partition" on page 63 and follow the instructions for creating a scalable partition. Notes: 1. When multiple cables are connected between the SMP Expansion Module ports, SMP data is interleaved between the cables for better performance. 2. The server will start and operate with one cable attached between the two SMP Expansion Modules. 36 xSeries 445 Type 8870: Installation Guide