IBM 887022X Installation Guide - Page 40
connector.
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Adapter guide Tab PCI-X divider Attention LED Power LED Adapter retention latch NOTE: FOR PROPER FRONT OF BOX AIRFLOW, NOTE: FOR PROPER AIRFLOW, FRONT OF BOX REPLACE FAN WITHIN 2 MINUTES REPLACE FAN WITHIN 2 MINUTES Figure 24. PCI-X slot components 3. See the documentation that comes with your adapter for any cabling instructions. Note: Route adapter cables before you install the adapter. 4. Set any jumpers or switches as described by the adapter manufacturer. Note: Do not install an adapter in PCI-X slot 1 if you are going to install the serial port that comes with your server. See "Installing the serial port" on page 31 for instructions for installing the serial port. 5. Install the adapter: a. Open the blue adapter guide by lifting the front edge, as shown in the illustration. b. Push the orange adapter retention latch toward the rear of the server and open the tab. c. Remove the expansion-slot cover and the PCI-X divider. d. Carefully grasp the adapter by its top edge or upper corners, and align it with the connector on the PCI-X board. e. If necessary, remove the extension handles or bracket before installing a long adapter. Attention: When you install an adapter, be sure the adapter is correctly seated in the connector. Improperly seated adapters might cause damage to the PCI-X board or to the adapter. 28 xSeries 445 Type 8870: Installation Guide