Icom IC-7100 Instruction Manual - Page 27
Connect controller to transceiver, ◇ The Main unit installation
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
2 INSTALLATION AND CONNECTIONS Connect controller to transceiver The Main unit becomes hot when transmitted for long period of time. DO NOT place anything on the transceiver. It may obstruct radiation and cause mechanical trouble. Rear panel Controller To the [CONTROLLER] connector Using Ferrite EMI filter* Depending on the installed condition of the transceiver, malfunction may occur by the wraparound of the electric wave. This problem can be resolved by using the Ferrite EMI filter. * The filter connection is required for the European versions. To the [MAIN UNIT] connector Ferrite EMI filter Controller cable DDThe Main unit installation MB-62 Main unit installation Nut Spring washer Drill 5 mm holes for the bracket location. Drill 3 mm holes for the tapping screws. Flat washer The MB-62 can be used for AT-180 as well. Screw Adjust for the best viewing angle. Using tapping screws Frange bolt IC-7100 2-3