Icom IC-7100 Instruction Manual - Page 28
Connecting accessories to the controller, CAUTION: NEVER
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
2 INSTALLATION AND CONNECTIONS Connecting accessories to the controller [MIC] Connector HM-151 HM-198 Adapter cable+Microphone Do not connect 2 microphones at same time. Both microphone have transmission if they are connected to controller and transceiver. CAUTION: NEVER connect or use the optional HM-151 (microphone) with any other transceiver. This could damage the transceiver. The HM-151 is designed to use with the IC-7000/ IC-7100 series ONLY. OPC-589 HM-36 SM-50 • External Keypad Control the CW memory keyer transmission from external keypad by connecting control circuit to MIC connector. Set the "Keyer" item in the "Connectors" Set mode to "ON," to use external keypad. (AI sec. 17) • Data transmission (AFSK) Connect TNC (Terminal Node Controller) to [MIC] connector to enable data transmission(AFSK). (AI sec 18) Controller Connect to the [CONTROLLER] connector of the Main unit [PHONES/SP](Headphone/External Speaker)Jack External spaeaker Set the switch under controller to "PHONES" to use headphone and set "SP" to use speaker. Bottom of the controller SP-35 (optional) The transceiver accepts headphones with maximum 5 mW in to an 8 Ω impedance. The sound level may differ, depending on the headphones. 3.5(d) mm/1⁄8˝ plug Headphone 2-4 [ELEC-KEY](Electronic keyer)Jack A jack to connect the paddle with electrode control on the end terminal. dash Connect to the [KEY] Jack of the Main unit when using an Electric keyer.(p. 2-5) dot ※Set internal keyer in de- com fault but it can be changed 3.5(d) mm/1⁄8˝ plug by the "Keyer" Set mode (AI sec. 4)