Icom IC-9700 Instruction Manual basic - Page 15

1 PANEL DESCRIPTION DDMulti-function menus Touch the edge to turn ON or OFF Rotate Push Multi-function menu zzOpen the Multi-function menu by pushing MULTI (Multi-function control). zzOpen special menus by holding down VOX/BK-IN , NB , NR , or NOTCH for 1 second. zzWhile the Multi-function menu is open, touch the desired item and rotate MULTI to set the desired value. Multi-function menu items *1 T ouch the edge to turn the function ON or OFF, or when you want to adjust. *2 Touch the item for 1 second to enable MULTI . SSB SSB-D CW RTTY RF POWER*2 RF POWER*2 RF POWER*2 RF POWER*2 MIC GAIN*2 MIC GAIN*2 KEY SPEED*2 TPF*1 COMP*1, *2 CW PITCH*2 MONITOR*1, *2 MONITOR*1, *2 MONITOR*1, *2 FM/AM/DV DD RF POWER*2 RF POWER*2 NB LEVEL*2 NR LEVEL*2 MIC GAIN*2 TX INHIBIT*1 DEPTH*2 WIDTH*2 MONITOR*1, *2 NOTCH POSITION*2 VOX GAIN*2 BK-IN DELAY*2 TX PWR LIMIT RF POWER*2 WIDTH*1 ANTI VOX*2 LIMIT DELAY*2 VOICE DELAY*1 Multi-function dial When the Multi-function menu is closed, MULTI can be enabled to adjust functions that are either on the upper right three keys or in the Multi-function menus. The function is displayed in the upper right edge of the screen. Function indicator for MULTI *1 You can independently enable MULTI to adjust the function for the MAIN and SUB bands. *2 On the Multi-function menus, touch the item for 1 second to assign the function to MULTI . Indicator Action RIT*1 Rotate Adjusts the RIT frequency. Hold down Clears the RIT frequency. kHz*1 Changes the operating frequency on the kHz steps. M-CH*1 Selects Memory channels. Using the DR function, selects an individual station or preset repeater. PBT1*1 Rotate Adjusts the Shift value for PBT1. Hold down Clears the Twin PBT setting. Rotate Adjusts the Shift value for PBT2. PBT2*1 Hold down Clears the Twin PBT setting. RF PWR*2 Adjusts the transmit output power. MIC G*2 Adjusts the microphone gain. COMP*2 Adjusts the Speech Compressor level. MONI*2 Adjusts the audio level for the Monitor function. SPEED*2 Sets the Key speed. PITCH*2 Sets the CW pitch. NB LEV*2 Adjusts the Noise Blanker level. NB DEP*2 Adjusts the DEPTH (Noise attenuation level). NB WID*2 Adjusts the WIDTH (Blanking duration time). NR LEV*2 Adjusts the transmit output power. NOTCH*2 Adjusts the Notch frequency. VOX G*2 Adjusts the VOX gain. A-VOX*2 Adjusts the ANTI VOX level. VOX D*2 Adjusts the VOX delay time. BKIN D*2 Adjusts the Break-in delay time. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 1-7