Icom IC-9700 Instruction Manual basic - Page 60

8 SET MODE Function (Continued) MENU » SET > Function AFC Limit (Default: ON) Select whether to limit the operating range of the AFC (Automatic Frequency Control) function, or not. ••OFF: Turns OFF the function. ••ON: Limits the operating range of the AFC function. The limit value differs depending on the IF filter width as described below. IF Filter width 15 kHz 10 kHz 7 kHz AFC limit value ±10 kHz ±7 kHz ±5 kHz [NOTCH] Switch (SSB) [NOTCH] Switch (AM) (Default: Auto/Manual) (Default: Auto/Manual) Selects the notch function used in the SSB or AM mode. ••Auto: Only the Auto Notch function can be used. ••Manual: Only the Manual Notch function can be used. ••Auto/Manual: Both the Auto and Manual Notch functions can be used. SSB/CW Synchronous Tuning (Default: OFF) Turns the Displayed Frequency Shift function ON or OFF. This function automatically shifts the frequency to match the CW pitch when the operating mode is toggled between SSB and CW. ••OFF: Turns OFF the function. ••ON: When the operating mode is changed between SSB and CW, the operating frequency shifts by the offset amount. CW Normal Side (Default: USB) Selects the carrier point in the CW normal mode. ••LSB: Sets the carrier point to the LSB side. ••USB: Sets the carrier point to the USB side. Keyboard Type (Default: Full Keyboard) Sets the keyboard entry type to Ten-Key or Full Keyboard. Full Keyboard Layout (Default: English) Selects the on-screen keyboard layout between English, German and French. Screen Capture [POWER] Switch (Default: OFF) Assigns the Screen Capture function to POWER . ••OFF: POWER does not act as the Screen Capture key. ••ON: POWER acts as the Screen Capture key. Screen Capture File Type (Default: PNG) Sets the file format for the Screen Capture function to PNG or BMP. MENU » SET > Function > REF Adjust REF Adjust Adjusts the internal reference frequency. REF Adjust (FINE) Fine tune the value set in "REF Adjust." NOTE: The default setting of "REF Adjust" may differ slightly, depending on the transceiver's version. My Station MENU » SET > My Station My Call Sign (DV) The transceiver has a total of 6 memories to save your own call signs for DV mode. You can enter a call sign of up to 8 digits. Also, a note of up to 4 characters, for operating transceiver type, area, and so on, can be entered. TX Message (DV) The transceiver has a total of 5 memories to save short messages for simultaneous transmission in the DV mode. Enter a message of up to 20 alphanumeric characters for each memory. LTo transmit no message, select "OFF." My Call Sign (DD) The transceiver has a total of 6 memories to save your own call signs for DD mode. You can enter a call sign of up to 8 digits. Also, a note of up to 4 characters, for operating transceiver type, area, and so on, can be entered. 8-5