Icom IC-9700 Instruction Manual basic - Page 69

SET MODE 8 MENU » SET > Connectors > USB (B)/DATA Function USB (B) Function (Default: OFF) The transceiver has 2 virtual COM ports, A and B. When connecting to a USB port on your PC, the ports are virtually named as USB (A) and USB (B). In this item, sets the function to be assigned to USB (B). USB (A) is used for programming, or CI-V operation. ••OFF: Does not assign the function to USB (B). ••RTTY Decode: Outputs the decoded data of the RTTY signal. ••DV Data: Inputs or outputs low speed data for the DV mode. DATA Function (Default: GPS/Weather) Sets the function to be assigned to the [DATA] jack. ••OFF: Does not assign the function to the [DATA] jack. ••RTTY Decode: Outputs the decoded data of the RTTY signal. ••DV Data: Inputs or outputs low speed data for the DV mode. ••GPS/Weather: Selected when connecting a GPS receiver. ••CI-V: Inputs or outputs CI-V commands. GPS Out (Default: OFF) Selects whether or not to output the position data to USB (B) when the GPS receiver is connected to the [DATA] jack. ••OFF: Does not output the position data to USB (B). ••DATA→USB (B): Outputs the position data to USB (B). LIt is valid when "USB (B) Function" is set to "OFF" or "DV Data," and "DATA Function" is set to "GPS/Weather." DV Data/GPS Out Baud Rate (Default: 9600) Sets the transfer rate of the DV data and the GPS output data. RTTY Decode Baud Rate (Default: 9600) Set the data transfer rate of the RTTY decoded signals. Network MENU » SET > Network 1 DHCP (Valid after Restart) 2 (Default: ON) Turns the DHCP function ON or OFF. ••OFF: Uses a static IP address. ••ON: Uses the DHCP function. 3 If a DHCP server is in your network environment, the IP address is automatically 4 obtained. 5 IP Address (Valid after Restart)  (Default: 192.168.0.10) 6 Sets the static IP address. 7 Subnet Mask (Valid after Restart)  (Default: 255.255.255. 0 (24 bit)) 8 Sets the subnet mask to connect to your PC or LAN (Local Area Network), through the Ethernet. 9 10 Default Gateway (Valid after Restart) (Default: . . . .) Sets the Default Gateway of the IC-9700. When you remotely control the IC-9700, a Default 11 Gateway setting is required. 12 Primary DNS Server (Valid after Restart)  13 (Default: . . . .) Sets the Primary DNS Server address. 14 2nd DNS Server (Valid after Restart) (Default: . . . .) If there are two DNS server addresses, sets the 15 secondary DNS server address. 16 Network Name If you are operating the IC-9700 using the optional 17 RS-BA1, enter a network name of up to 15 characters. 18 Network Control (Valid after Restart) (Default: OFF) 19 Selects whether or not to remotely control the IC-9700. ••OFF: Disables remote control of the IC-9700. ••ON: Enables remote control of the IC-9700. 20 Power OFF Setting (for Remote Control)  (Default: Shutdown only) 21 Selects whether or not to display the Standby/ Shutdown option dialog after holding down POWER for 1 second. ••Shutdown only: Shut down the IC-9700 when you turn it OFF. ••Standby/Shutdown: Displays the Standby/Shutdown option dialog when you turn it OFF. 8-14