Icom IC-9700 Instruction Manual basic - Page 68
CI-V USB/LAN→REMOTE Transceive Address
View all Icom IC-9700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
8 SET MODE Connectors (Continued) MENU » SET > Connectors > USB SEND/Keying Inhibit Timer at USB Connection (Default: ON) Sets to prevent unintentional SEND or Keying signal transmission, under the following conditions. - When connecting a PC to the transceiver using a USB cable. - While the transceiver and a PC are connected using a USB cable, or when starting up the PC or connecting or disconnecting a USB device to or from the PC. - When a virtual serial port communication has been established. ••OFF: The transceiver transmits the SEND or Keying signal right after a PC or USB device is connected. ••ON: The transceiver transmits after a few seconds have passed, to prevent unintentional transmission. LIf you change this setting to "OFF," update the transceiver's USB driver and make sure the SEND or Keying signal will not be unintentionally transmitted. MENU » SET > Connectors > External Keypad VOICE KEYER RTTY (Default: OFF) (Default: OFF) (Default: OFF) Enables each memory (voice, keyer, RTTY) transmission using an external keypad. MENU » SET > Connectors > CI-V CI-V Baud Rate (Default: Auto) Selects the CI-V data transfer rate. LWhen "Auto" is selected, the baud rate is automatically set according to the data rate of the connected device. CI-V Address (Default: A2h) Sets the CI-V address. L"A2h" is the default address of the IC-9700. CI-V Transceive (Default: ON) Turns the Transceive function ON or OFF. ••OFF: The status is not output. ••ON: The status is output. When you change a setting on the transceiver, the same change is automatically set on other connected transceivers or receivers, and vice versa. CI-V USB/LAN→REMOTE Transceive Address (Default: 00h) Sets the address used to remotely control the transceiver or the receiver, through the [USB] port or the [LAN] port. The external equipment control signal is output from the [REMOTE] jack. CI-V USB Port (Default: Unlink from [REMOTE]) Selects the internal connection type between the [USB] and [REMOTE] CI-V ports. ••Link to [REMOTE]: The [USB] and [REMOTE] CI-V ports are internally connected. ••Unlink from [REMOTE]: The [USB] and [REMOTE] CI-V ports are not internally connected. Each port functions independently. CI-V USB Baud Rate (Default: Auto) Selects the CI-V data transfer rate when remotely controlling the IC-9700 through the [USB] CI-V port. LWhen "Auto" is selected, the baud rate is automatically set according to the data rate of the external device. LThis setting is valid only when the "CI-V USB Port" item is set to "Unlink from [REMOTE]." CI-V USB Echo Back (Default: OFF) Turns the Data Echo Back function ON or OFF, when remotely controlling the IC-9700 through the [USB] CI-V port. LThis setting is valid only when the "CI-V USB Port" item is set to "Unlink from [REMOTE]." CI-V DATA Baud Rate (Default: OFF) Selects the CI-V data transfer rate when remotely controlling the IC-9700 through the [DATA] jack. CI-V DATA Echo Back (Default: OFF) Turns the Data Echo Back function ON or OFF, when remotely controlling the IC-9700 through the [DATA] jack. 8-13