Lexmark Optra T616 Administrator's Guide (1.4 MB) - Page 126

Replacing the fuser assembly CAUTION: The fuser assembly is hot! Turn the printer off and wait twenty minutes before changing the fuser assembly. NOTE: For best results, use Lexmark supplies with the printer. If you are in the U.S. or Canada, call 1-800-438-2468 for information about Lexmark Authorized Supplies Dealers in your area. In other countries, contact the place where you bought your printer. You should order a new fuser assembly when toner fog or background shading appears on printed pages. See page 129 for ordering a fuser assembly. Complete the following steps to replace the fuser assembly. Refer to the documentation that comes with the fuser assembly for detailed installation information. 1 Turn the printer off, unplug the printer power cord, and wait twenty minutes. 2 Remove the top cover and all installed output options. If you have a duplex unit remove the printer from the duplex unit. 3 Remove the fuser cover. (If you have a label printer, lift up and remove the fuser cleaner.) 4 Open the rear access door and remove the redrive. 5 Remove the old fuser assembly. 6 Install the new fuser assembly and replace the redrive. 7 Close the rear access door and replace the fuser cover if necessary. 8 If you have a duplex unit, reinstall the printer on it. Reinstall all output options and the top cover. 9 Plug the printer power cord into a properly grounded electrical outlet and turn the printer on. Maintaining Your Printer 126