LiftMaster GH GT- Logic 4 Installation Manual - Page 3

SAFETY INFORMATION SAFETY INFORMATION WARNING Mechanical CWAWAUARTRINONINNINGG Electrical CWAUATRIONINNG WARNING IMPORTANT NOTES: • BEFORE attempting to install, operate or maintain the operator, you must read and fully understand this manual and follow all safety instructions. WARNING • DO NOT attempt repair or service of your commercial door and WARNING gate operator unless you are an Authorized Service Technician. • Operator intended to be installed on a properly balanced door WARNING WARNING only. Make sure door is properly balanced before installing. When you see these Safety Symbols and Signal Words on the following pages, they will alert you to the possibility of serious injury or death if you do not comply with the warnings that accompany them. The hazard may come from something mechanical or from electric shock. Read the warnings carefully. WARNING When you see this Signal Word on the following pages, it will alert you to the possibility of damage to your door and/or the door operator if you do not comply with the cautionary AVERTISSEMENT statements that accompany it. Read them carefully. AVERTISSEMENT AAAVVETEITRMRETPTNIOSISTRSISOTEEANMMNETENNITNTSTALLATION INSTRUCTIAOANVVSEERRTTIISSSSEEMMEENNTT WARNING TAOAVRTEETRDETUNICSTESIOTENHMEERNISTK OF SEVERE INJURY OR DAEVAETRH:TISSEMENT 1. READ AND FOLLOW ALL INSTALLATION WARNINGS AND INSTRUCTIONS. 2. Install door operator ONLY on properly balanced and lubricated door. An improperly balanced door may NOT reverse when required and could result in SEVERE INJURY or DEATH. 3. ALL repairs to cables, spring assemblies and other hardware MUST be made by a trained door systems technician BEFORE installing operator. 4. Disable ALL locks and remove ALL ropes connected to door BEFORE installing operator to avoid entanglement. 5. Install door operator 8 feet (2.44 m) or more above floor. ADVERTENCIA 6. NEVER connect door operator to power source until instructed to do so. 7. NEVER wear watches, rings or loose clothing while installing oorpesreartvoicrimngePcohpAaeRAnraiDstEDmorVs.CV.TEhAEeyRRUcoTuTCldEEbIeNÓNcaCNuCghIItAAin door or 8. Install control station: • within sight of the door. • out of reach of children at minimum height of 5 feet (1.5 m). • away from ALL moving parts of the door. 9. Install the control station far enough from the door to prevent the user from coming in contact with the door while operating the controls. 10. Install the entrapment warning placard on wall next to the control station in a prominent location that is visible from the door. 11. Place manual release/safety reverse test label in plain view on inside of door. ADVERTENCIA 12. Upon completion of installation, test entrapment protection device. 13. SAVE THESE INSTARADUDVCVTEEIRORNTTSEE.NNCCIIAA PRAEDCVAERUTCEIÓNNCIA ADVERTENCIA 3 Safety Information