Panasonic AG-HMX100 Operating Instructions - Page 20

Basic Operation Setting Screen When setting up this unit or adjusting functions, you need to check the current settings on the LCD screen. The following shows the basic configuration of the setting screen. 1 2 3 POS. X 128 Y 128 Z 196 EVENT ME TIME 00 E 2:00 F VIDEO EFFECTS FAN STOP PATTERN INT 3044 WHT CH A MOSAIC DEFOCUS MONO SIZE OFF XY 0 LEVEL OFF 0 OFF 45 6 1 Joystick, rotary Z control settings, and 3D display area Shows the setting values of the joystick and rotary Z control; X, Y, and Z values during position setting and PB, PR, and C GAIN values during color setting. When this unit is in 3D mode ( page Vol. 2-25), [3D] is displayed. 2 Audio level meter Indicates the audio output level. 3 Error Message An error message appears in the following cases. Message Condition and Action FAN STOP The fan has stopped from any cause. Immediately turn off the power and request a service call ( page 39). CHANGE HDMI HDMI input source in the format other FORMAT than the system formats ( page 19) CHANGE HDMI1 available for this unit is being FORMAT connected to this unit. CHANGE HDMI2 CHANGE HDMI FORMAT: Input FORMAT sources of both HDMI IN connectors are in unavailable formats. CHANGE HDMI1 FORMAT: Input source of the HDMI IN 1 connector is in unavailable format. CHANGE HDMI2 FORMAT: Input source of the HDMI IN 2 connector is in unavailable format. Change the system format setting or the input source setting.  NOTE The "FAN STOP" error message is also displayed on the multi-view screen. However, since the multi-view screen does not open when this unit is in 3D mode ( page Vol.2-25), no error message is displayed even if the fan stops. Pay attention to a message which will appear on the LCD. If two types of errors occur at the same time, "FAN STOP" is displayed preferentially. 4 Event number, transition time, pattern number, and internal video display area EVENT: Shows the event number ( page Vol.2-20). ME TIME: Shows the setting value of transition time ( page 35); DSK TIME value during downstream key setting ( page 37) and FADE TIME value during fade setting ( page 38). To change the TIME type, press the applicable transition time setting button (ME, DSK, or FADE) to turn on. PATTERN: Shows the number of the currently selected pattern ( page 35). INT: Shows the type of the currently selected internal (internally generated) video ( page 28). 5 Menu title, related information, rotary 1 to 5 parameter display area Shows the title of the currently selected menu ( page 21) (e.g., VIDEO EFFECTS), bus settings (A/B), related information (color settings, etc), and setting positions of rotary 1 to 5 controls. 20