Panasonic AG-HMX100 Operating Instructions - Page 24

Basic Operation Example of DIRECT PATTERN KEY screen POS. X 128 Y 128 Z 196 EVENT ME TIME 00 E 1:00 F DIRECT PATTERN KEY PATTERN INT 3002 WHT ENTER TO EXIT PATTERN EDGE EFFECTS KEY LEARN WIDTH COLOR K LEVEL HARD 16 WHITE 255 OFF EMPTY 9000 SETUP Up to six key patterns can be stored. It is also possible to change the settings for the edge of each pattern or set and store effects for each pattern ( page Vol.2-5). To use the factory default settings 1 Select [DEFAULT] using the rotary 2 control, and press the key. 2 When the message [OK?] appears, press the key. To stop the setting process, press the key while holding down the SHIFT key. The display returns to the [SETUP] menu screen. Setting Video and Audio Input Sources [AUDIO VIDEO] The [AUDIO VIDEO] submenu of the [SETUP] menu is used to select video and audio input sources to be processed or mixed. Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5 AUDIO INPUT VIDEO SETUP AUX WFM SDI1 SDI1 SETUP DEFAULT V-LINK SDI1 SDI2 SDI3 SDI4 HDMI1 (VIDEO1)*1 HDMI2 (VIDEO2)*1 PGM PVW M VIEW SDI1 SDI2 SDI3 SDI4 HDMI1 (VIDEO1)*1 HDMI2 (VIDEO2)*1 DVI-I *1 VIDEO1 and VIDEO2 are displayed as choices when the current system format is SD ( page 19). HDMI1 and HDMI2 are displayed when the current system format is HD. The video and audio input source settings are stored individually for the following three cases. • When the system format setting is SD ( page 19). • When the system format setting is HD ( page 19). • 3D mode setting is other than [OFF]. The stored settings are read out each time the system format is changed. To display the Audio/Video Input Source Setting screen 1 Set [INPUT] to [SETUP] using the rotary 2 control, and press the key. 2 When the message [OK?] appears, press the key again. The Audio/Video Input Source Setting screen appears. To cancel the setting, press the key while holding the SHIFT key. The display returns to the [SETUP] menu screen. Audio/Video Input Source Setting screen Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5 1 V S-1 SDI A S-1 SDI 2 V S-2 SDI A S-2 SDI 3 V S-3 SDI A S-3 SDI 4 V S-4 SDI A S-4 SDI 5 V S-1 HDMI A S-1 HDMI 6 V S-2 HDMI A S-2 HDMI 7 V S-1 DVI-I A S-1 ANALOG 8 V S-2 SDI A S-2 ANALOG V S-1 V S-2 V S-3 V S-4 SDI HDMI VIDEO DVI-I A S-1 A S-2 A S-3 A S-4 SDI HDMI ANALOG  NOTE If the 3D mode is set to [MODE3-M] or [MODE3-S], neither [INPUT] item nor setting screen appears. To select the number of an input source Use one of the following two methods: • Select the input source number on the Audio/Video Input Source Setting screen using the rotary 1 control. The rotary 1 control allows you to select the program input source number of bus A. • Use the A/PROG or B/PRESET bus source selector buttons. To select sources 5 to 8, press the corresponding A/ PROG (or B/PRESET) bus source selector button while holding down the SHIFT button. The pressed button flashes. 24