Panasonic AG-HMX100 Operating Instructions-Advanced - Page 16

Chapter 1 Applying Effects to Video and Sound [DECAY] The afterimage effect can be added to video. The following diagram shows an example of the decay effect. [NEGA] The brightness of video can be inverted. The following diagram shows an example of the negative effect. Decay effect Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5 DECAY TIME OFF 16 OFF 0-32 ON Negative effect Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5 NEGA Y C OFF OFF OFF OFF ON ON Select [ON] or [OFF] to specify whether or not to apply the effect using the rotary 2 control. The factory default setting is [OFF]. Set [TIME] in the range of [0] to [32] using the rotary 3 control. The factory default setting is [16]. This time setting is applied to No. 1066 (219) pattern.  NOTE The decay effect cannot be applied to both input source video A and B at the same time. When the decay effect is enabled for one video, it is automatically disabled for the other video. Select [ON] or [OFF] to specify whether or not to apply the Y signal negative setting [Y] using the rotary 2 control and the chroma signal negative setting [C] using the rotary 3 control, respectively. The factory default setting is [OFF] for both items. [MIRROR] The mirror effect can be produced in the horizontal or vertical directions. The following diagram shows an example of the mirror effect. [PAINT] The image tone can be decreased to generate painting-like video. The following diagram shows an example of the paint effect. Horizontal direction Paint effect Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5 PAINT LEVEL OFF 4 OFF 0-7 ON Select [ON] or [OFF] to specify whether or not to apply the effect using the rotary 2 control. The factory default setting is [OFF]. Set [LEVEL] in the range of 0 to 7 using the rotary 3 control. The factory default setting is 4. This level setting is applied to No. 1034 (211) transition pattern. Vertical direction Horizontal and vertical directions Mirror effect Rotary 1 Rotary 2 Rotary 3 Rotary 4 Rotary 5 MIRROR H V OFF OFF OFF OFF ON ON Select [ON] or [OFF] to specify whether or not to apply the mirror setting in the horizontal direction [H] using the rotary 2 control and in the vertical direction [V] using the rotary 3 control, respectively. The factory default setting is [OFF] for both items. 16