Panasonic PT-D7700U-K Dlp Projector - English/ French - Page 56
Sharpness / Gamma / Noise Reduction, To Display Pictures Complying With The Srgb Standard
UPC - 791871111000
View all Panasonic PT-D7700U-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Adjusting the picture Sharpness / Gamma / Noise reduction Procedure of adjustment MAIN MENU PICTURE POSITION ADVANCED MENU LANGUAGE OPTION TEST PATTERN SIGNAL LIST SECURITY Press the "MENU" button. The MAIN MENU screen will be displayed. Select "PICTURE" with the buttons. PICTURE PICTURE MODE COLOR TINT COLOR TEMP. GAMMA CONTRAST BRIGHT SHARPNESS NOISE REDUCTION DYNAMIC IRIS :MENU SELECT :ADJUST DYNAMIC 50 30 DEFAULT 2.2 32 32 6 2 1 Press the "ENTER" button. The PICTURE screen will be displayed. Select desired one of the items in the following table with the buttons. Switch the setting with the buttons. Refer to the following table for the items and the details. Adjustment items Sharpness Gamma selection Noise reduction Operation Sharpens the outline of the image. Adjustment 0 to 7 for the RGB system and the HD system (factory setting is 2) 0 to 15 for the SD system (factory setting is 6) Switches the gamma modes 5 settings: DEFAULT, USER1, USER2, 2.2 and 2.5 (factory setting: DEFAULT) Switches the noise reduction effect Four types: OFF (no correction), 1 (low), mode. 2 (middle), 3 (high) (factory default: 2) Note • Noise reduction cannot be adjusted with analog RGB input, DVI input or network input. • Separate software is required to select "USER1" and "USER2" as the gamma setting. Consult your dealer. To display pictures complying with the sRGB standard sRGB is the international color reproduction standard (IEC61966-2-1) established by IEC (International Electrotechnical Commission). To reproduce colors more faithfully in compliance with the sRGB standard, perform the following setting procedure. 1. Set color matching adjustment to "OFF". 2. Press the buttons on the "PICTURE" menu and select the "PICTURE MODE". Set to "NATURAL" with the buttons. 3. Select the "COLOR" with the buttons. Press the STD (standard) button on the remote control to restore the factory default. Follow the same procedure to restore the factory default for "TINT", "COLOR TEMP." and "GAMMA". Note • sRGB is only enable when RGB signals are being input. 56