Panasonic PT-D7700U-K Dlp Projector - English/ French - Page 83
CONTROL COMMANDS, CABLE SPECIFACATIONS, Remarks, Command, Projector, Computer
UPC - 791871111000
View all Panasonic PT-D7700U-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Control commands When controlling the projector from a computer, the following commands are available: Command Function of command Remarks PON Power "ON" POF Power "OFF" In standby mode, commands other than "PON" are invalid. • While the lamp is ON and being controlled, a "PON" command will not be accepted. Parameter I I S Switch input modes VID = VIDEO SVD = S-VIDEO RG1 = RGB1 RG2 = RGB2 AUX=AUX QSL LPM OLP Query for active lamp mode Parameter 0 = DUAL 1 = SINGLE 2 = LAMP 1 3 = LAMP 2 Active lamp mode Parameter 0 = DUAL 1 = SINGLE 2 = Only LAMP 1 is on 3 = Only LAMP 2 is on Parameter Lamp power setting 0 = HIGH, 1= LOW "SINGLE" will use the lamp (LAMP 1 or LAMP 2) with shorter operating hours. Note • If you need a detailed command list, please contact your dealer. Cable specifications Projector 1 NC 2 3 4 NC 5 6 NC 7 8 9 NC Computer (DTE specifications) NC 1 2 3 NC 4 5 NC 6 7 8 NC 9 Attention • To connect the computer to the SERIAL terminal, prepare an adequate communication cable that fits to your personal computer. 83