Pioneer DEH-P710BT Owner's Manual - Page 50
Switching the dimmer setting, Adjusting the brightness, Setting the rear output and, subwoofer output
UPC - 012562943534
View all Pioneer DEH-P710BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Section 11 Initial Settings Switching the dimmer setting To prevent the display from being too bright at night, the display is automatically dimmed when the car's headlights are turned on. You can turn the dimmer on or off. 1 Display the initial setting menu. Refer to Adjusting initial settings on page 48. 2 Use MULTI-CONTROL to select Dimmer in the initial setting menu. 3 Press MULTI-CONTROL to turn dimmer on. # To turn dimmer off, press MULTI-CONTROL again. Adjusting the brightness You can adjust the display brightness. 1 Display the initial setting menu. Refer to Adjusting initial settings on page 48. 2 Use MULTI-CONTROL to select Brightness in the initial setting menu. 3 Push MULTI-CONTROL left or right to adjust the brightness level. 0 to 15 is displayed as the level is increased or decreased. # When dimmer is functioning, the brightness level can be adjusted 0 to 10. Setting the rear output and subwoofer output This unit's rear output (rear speaker leads output and RCA rear output) can be used for fullrange speaker (Rear SP :F.Range) or subwoofer (Rear SP :S/W) connection. If you switch the rear output setting to Rear SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speaker connection (Rear SP :F.Range). 1 Display the initial setting menu. Refer to Adjusting initial settings on page 48. 2 Use MULTI-CONTROL to select S/W control in the initial setting menu. 3 Press MULTI-CONTROL to switch the rear output setting. Pressing MULTI-CONTROL will switch between Rear SP :F.Range (full-range speaker) and Rear SP :S/W (subwoofer) and that status will be displayed. # When no subwoofer is connected to the rear output, select Rear SP :F.Range (full-range speaker). # When a subwoofer is connected to the rear output, select Rear SP :S/W (subwoofer). Notes ! Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 45). ! If you change this setting, subwoofer output in the audio menu will return to the factory settings. ! Both rear speaker lead outputs and RCA rear output are switched simultaneously in this setting. Setting the internal power amplifier This unit features high power amplifier. However, in particular system, external amplifiers are used instead of internal amplifier. If you use external amplifiers in order to establish a multi-amp system, and don't use internal amplifier, it is recommended to turn off the internal amplifier. Turning off internal amplifier reduces the noise that comes from the behavior of internal amplifier. 1 Display the initial setting menu. Refer to Adjusting initial settings on page 48. 50 En