Samsung RF34H9960S4 User Manual Ver.0.3 (English, French, Spanish) - Page 17
How To Adjust The Door, Height, How To Adjust The Door Gap
View all Samsung RF34H9960S4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
SETTING UP HOW TO ADJUST THE DOOR HEIGHT If any one of the doors is lower than the other: • Check if the Refrigerator is level before adjusting the door. • Adjust the door height difference by inserting a Snap Ring ( 1 ) as shown between the door and the hinge. You can use the rings to raise the right side door of the fresh food compartment and both doors of the freezer compartment. Snap Rings included with the refrigerator: 1 mm 1.5 mm 2 mm 2.5 mm HOW TO ADJUST THE DOOR GAP If the gap between the left and right fridge compartment doors is not even. • You can adjust the gap by turning the bolt at the top right of the cold storage compartment door. • Do not turn the bolt too far. You can break it. 1 • After checking the height difference, select one Snap Ring with a suitable thickness. Important: You can only insert one snap ring. Inserting two or more Snap Rings may cause the Snap Rings to slip out or make a rubbing noise. • Lift up the lower door and insert the Snap Ring into the space between the Door and the Hinge. 1. With the doors closed, remove the 6 screws holding the top cover using a Phillips screwdriver, and then lift it off together with the connected cables. • To avoid injury, insert or remove Snap CAUTION Rings carefully. • Keep the Snap Rings out of the reach of children and make sure that children do not play with them or put them into their mouths. 2. Turn the bolt with a 4 mm hexagonal L-wrench to adjust the gap. (Not provided) • Two 1 mm, 1.5 mm, 2 mm, and 2.5 mm Snap Rings come with the Refrigerator. • If the Refrigerator is level before you load it with food, the Refrigerator may become unbalanced due to the weight of the food. If this occurs, adjust the level again using the same procedure. • If you raise the door too far, it can rub against the Top Cover. 3. Turn the bolt clockwise to ( ) widen the gap. Turn the bolt counter clockwise ( ) to narrow the gap. English - 17 DA68-03013A-03.indb 17 2014. 2. 25. 4:04