Samsung SCX4521F Service Manual - Page 78

Alignment and Adjustments STATUS BY PASS JAM GROUP is not available LCD Display [Bypass Jam] Group Not Available RETRY REDIAL? Retry Redial ? NO. NOT ASSIGNED Load document NO. Not Assigned Load Document Memory full and canel the job Cancel ? 1:Yes 2:No Job has not been created Low Heat Error Open Fuser Error Over Heat Error Memory Dial Full Operation Not Assigned [Low Heat Error] Open Fuser Error [Over Heat] [Jam 1] [No Catridge] Memory Dial Full Descriptions When the machine detected the non feeding from BYPASS Tray. You have tried to select a group location where only a single Location number can be used. the machine is waiting for the programmed interval to automatically redial a previously busy station. The speed dial location you tried to use has no number assigned to it. You have attempted to set up a sending operation with no Document loaded. When the machine has encountered the memory full during storing the document into memory, the machine display the "CANCEL ?" to operator whether he/she make a decision the canceling the job or accept the scanned page so far to transmit the remained documents. When operator is doing in ADD/CANCEL operation and There is no job to handle if operator entered the job no. Temperature could not reach certain level. The thermister has been disconnected. Temperature has gone up very high degree. When the machine detected the toner cartridge has not been installed, or detected jam1 in warmup state. During Auto dial transmission when all 15 jobs are configured and try to add 16th job Samsung Electronics Service Manual 4-18