Sharp MX-M503 MXM283 MXM363 MXM453 MXM503 Operation Guide - Page 633

DOCUMENT FILING SENDING A STORED FILE A file stored by document filing can be retrieved and transmitted whenever needed. The settings used when the file was stored are also stored, and thus the file can be transmitted using those settings. If needed, you can also change the transmission settings to modify the retrieved file. After selecting the desired file, follow the steps below. ☞ SELECTING A FILE (page 6-29) 1 Job Settings file-01 Select the job. Print Move Name 1 8½x11 Cancel F. Color Send Delete Property Change Image Check Detail Touch the [Send] key. 2 Address Book Address Entry file-01 F. Color Send Settings Resolution 200X200dpi File Format PDF Special Modes Name 1 B/W Send 3 Press the [START] key. Select transmission settings. For information on the settings, see "SEND SETTINGS SCREEN" (page 6-38). • A file saved in black and white or grayscale cannot be transmitted in color. • A stored print job cannot be transmitted. • These transmission methods require installation of the corresponding options. • If any of the following special modes were included in the saved file, the file cannot be transmitted. "Pamphlet Copy", "Covers/Inserts", "Photo Repeat", "Multi-Page Enlargement", "Multi Shot" for copying. • If any of the following special modes were included in the saved file, the file can be transmitted but the special modes will not be executed. "Margin Shift", "Transparency Inserts", "Book Copy", "Tab Copy", "Stamp", "Sharpness", "Centering" • Depending on the reduction or enlargement ratio used when storing a file, it may not be possible to send the stored file using a selected resolution setting. In this event, try changing the resolution. However, when sending a stored file by Internet fax, transmission may not be possible even if the resolution is changed. • A scanned file that was saved in [High Capacity Mode] cannot be transmitted. 6-37 Contents