Sharp MX-M503 MXM283 MXM363 MXM453 MXM503 Operation Guide - Page 773

TROUBLESHOOTING COPYING PROBLEMS RELATED TO COPYING OPERATION • Copying does not take place 8-15 • Image rotation does not take place 8-15 • Two-sided copying does not take place 8-16 • The paper size of a tray cannot be set 8-16 PROBLEMS RELATED TO COPY RESULTS • The image is too light or too dark 8-17 • Part of the image is cut off 8-17 • Copies come out blank 8-17 • If you cannot find the item that you are looking for in the above table of contents, see "GENERAL PROBLEMS" (page 8-37). • If you are unable to solve a problem using the solutions in this manual, switch off the [POWER] key ( ) and the main power switch. Wait at least 10 seconds, and then switch on the main power switch and the [POWER] key ( ) in that order. When the LINE indicator is lit or the DATA indicator is lit or blinking, do not switch off the main power switch or unplug the power plug. This may damage the hard drive or cause the data being stored or received to be lost. PROBLEMS RELATED TO COPYING OPERATION Problem Copying does not take place. Point to check Have functions been disabled by the administrator? Image rotation does not take place. Did you select the paper size or copy ratio manually? Are you copying using settings that do not allow rotate copying? Is "Rotation Copy Setting" disabled in the system settings (administrator)? Solution When user authentication is enabled, the functions that you can use may be restricted in your user settings. Check with your administrator. Copy using automatic paper selection and automatic ratio selection. Rotate copying can generally be combined with other special modes, however, some combinations are not possible. If a prohibited combination is selected, a message will appear in the touch panel. Check with your administrator. If you are the administrator, enable "Rotation Copy Setting". ➞ System Settings (Administrator) > "Copy Function Settings" > "Other Settings" > "Rotation Copy Setting" > 8-15 Contents