Sony UWPV6/4244 Operating Instructions - Page 28
Parts Identification, Body-pack transmitter (UTX-B2
View all Sony UWPV6/4244 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Parts Identification Body-pack transmitter (UTX-B2) a Antenna b MIC/LINE (microphone/line) input selector Set according to the equipment connected to the audio input connector. Note Do not set the MIC/LINE input selector to MIC position while the audio signal is being input from the audio mixer, etc. Doing so may cause excessive audio input, resulting in distorted playback or recorded sound or damage to the playback or recording equipment. c Audio input connector Connect the supplied lavalier microphone here. By using a commercially available XLR-BMP conversion input cable, UTXB2, the line output connector of the audio mixer or the microphone which does not require the external power supply can also be connected. Notes • When the MIC/LINE input selector is set to MIC position, a power voltage for the supplied lavalier microphone is applied to the audio input connector. For this purpose, a special electrical wiring is used inside this connector. Be sure to use a commercially available XLR-BMP conversion input cable to connect the equipment other than the supplied lavalier microphone. • Note that the proper performance may not be obtained if a lavalier microphone which is not supplied with the UWP series package is used. d AF/PEAK (audio frequency/peak level) indicator Turns on or off according to the audio input level as follows. On (red): Audio input level is too high. If the sound is distorted, increase the attenuation level of the audio input (see page 49). On (green): Audio input level is appropriate. Off: There is no audio input or input level is too low. e POWER switch Turns the power of the transmitter ON or OFF. f Battery compartment Accommodates two LR6 (size AA) alkaline batteries. 28 Parts Identification