Sony UWPV6/4244 Operating Instructions - Page 56

Symptom Meanings Remedy The sound is weak. The attenuation level on the transmitter is too high. The input level of the transmitter is low. Press the - button on the transmitter in attenuation level setting mode to decrease the attenuation level. The volume on the amplifier Adjust the volume. or mixer is low. The line input is selected on Select the microphone input on the the transmitter.2) transmitter. There is distortion The attenuation level of the in the sound. transmitter is too low. The input level of the tuner is extremely high. Press the + button on the transmitter in attenuation level setting mode to raise the attenuation level. The transmitter and the tuner Set the transmitter to the same are set to different channels. channel. Headphones with a monaural Use the headphones with a stereo mini jack is used.3) mini jack. The line output signal is input to the transmitter when the MIC/LINE input selector (or INPUT selector) is set to MIC position.4) Set the MIC/LINE input selector (or INPUT selector) to LINE position. There is sound interruption or noise. The transmitter and the tuner Set the transmitter to the same are set to different channels. channel as the tuner. Two or more transmitters are Set each transmitter to a different set to the same channel. channel. The transmitters are not set to the channels within the same channel group. The channel plan which the UWP series components use is set so that no signal interference occurs when 2 or more transmitters are used simultaneously. Set each transmitter to a different channel within the same channel group. Two or more UWP series packages are operated at close channels. • Select channels within the same channel group (except channel group 00). • Use the channels at least 2channel intervals (250 kHz). 56 Troubleshooting