Sony UWPV6/4244 Operating Instructions - Page 44

Hold down the + or - button to change the channel group faster. 4 When the desired channel group number appears, press the SET button. The selected group is entered. The right four digits start to flash to allow the selection of the channel number. To select the channel by frequency indication 1 Press the SET button for more than one second. Keep pressing the SET button until the display section parameters start to flash. 2 Press the SET button repeatedly until the frequency indication appears and starts flashing. 5 Press the + or - button to select the channel number. The channel indication changes in the order shown in the tables in the pdf files "Sony Wireless Microphone System Frequency List" on the supplied CD-ROM (for U30, U42, CE62, and CE67 models). Example: When the channel group 00 is selected 6 When the desired channel number appears, leave the tuner for about 10 seconds or press down the SET button for more than one second. The selected channel number stops flashing and the selection is stored in memory. 3 Press the + or - button to select the frequency. 4 When the desired frequency appears, leave the tuner for about 10 seconds or press down the SET button for more than one second. The selected channel number stops flashing and the selection is stored in memory. Notes • Even when you are setting the reception channel, the tuner can be used to receive signals. • Do not remove the batteries while setting the reception channel. If they are inadvertently removed, re-insert them immediately and redo the procedure "Setting the reception channel" from step 1. • Make sure that the selected channel is the same on the transmitter and tuner being used in the same system. • If you turn off the tuner and then immediately turn it on right after setting the reception channel, the unit may not 44 Tuner Settings