Yamaha CLP-380 Owner's Manual - Page 120

Keyboard Stand Assembly 7. Attach C. 7-1 Place on D, the stopper-wood at the bottom edges of C, then secure the top. 7-2 Secure upper right and left of C using two 4 x 14mm thin screws. 7-3 Secure upper center and lower of C using five 4 x 20mm tapping screws. 7-2 Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the [AC IN] and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. WARNING An improper voltage setting can cause serious damage to the Clavinova or result in improper operation. 7-1 C D C 9. Set the adjuster. Rotate the adjuster until it comes in firm contact with the floor surface. 7-3 8. Connect the power cord. Insert the AC power cord plug into the [AC IN]. 10.Attach the headphone hanger. You can attach a headphone hanger on the Clavinova to hang the headphones. Install the headphone hanger using included two screws (4 x 10mm) as shown in the figure. 240 For models that feature a voltage selector: 220 Set the voltage selector to an 127 appropriate voltage. 110 Appendix 120 CLP-380 Owner's Manual