Yamaha D24 Owner's Manual - Page 100
Copying Parts
View all Yamaha D24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
96 Chapter 10-Editing Parts Copying Parts The Part Copy function is used to copy part of a track. Existing material on the destination track is overwritten by the Copy function. The source track is unaffected. The following points, which can be adjusted in sub-frame steps, can be selected when specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from 1 through 99. Note that you must set these points before entering the Part Copy function. See the Quick Locate Chapter on page 57 for more information about setting these points. 1 Press the [EDIT] button. The EDIT indicator lights up. 2 Use the JOG/DATA dial to select "PART EDIT," and then press the [ENTER] button. 3 Use the JOG/DATA dial to select "COPY," and then press the [ENTER] button. "PART COPY-FROM TR nn" appears on the display ("nn" being the number of the track from which the part is to be copied). 4 Use the JOG/DATA dial to select the source track. You can select individual tracks, track pairs, or all tracks: 1-8, 1/2-7/8, or ALL. To copy part of a virtual track, assign it to a main track first, and then copy. 5 Press the [ENTER] button. "COPY TR nn-ST MARK IN" appears on the display ("nn" being the number of the selected track and "ST" being the start point of the part to be copied). 6 Use the JOG/DATA dial to select one of the following points: MARK IN, MARK OUT, MARK A, MARK B, or a locate memory from 1 through 99. 7 Press the [ENTER] button. "COPY TR nn-ST 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the position of the selected point). 8 Use the JOG/DATA dial or keypad to adjust the start position, and then press the [ENTER] button. "COPY TR nn-ED MARK IN" appears on the display ("ED" being the end point of the part to be copied). 9 Use the JOG/DATA dial to select one of the following points: MARK IN, MARK OUT, MARK A, MARK B, or a locate memory from 1 through 99. 10 Press the [ENTER] button. If the duration of the specified part is less than 15 milliseconds, the minimum size, the message "TOO SHORT" appears. "COPY TR nn-ED 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the position of the selected point). 11 Use the JOG/DATA dial or keypad to adjust the end position, and then press the [ENTER] button. "COPY TR nn-TO TR nn" appears on the display ("TO TR nn" being the destination track). D24-Owner's Manual