Yamaha D24 Owner's Manual - Page 68
Locating Positions Directly, ti tle
View all Yamaha D24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Locating Positions Directly 63 Locating Positions Directly Positions can be located directly by entering time values. 1 Use the keypad to enter the position that you want to locate, starting with hours, minutes, and seconds. To enter the position 3 minutes and 27 seconds (00:03:27), for example, press [3], [2], and [7]. The entered value appears on the 2nd line of the display, as shown below. 0 0H 0 0M 0 0S 0 0F 01 no ti tl e 0003 27 Press the [CANCEL] button to reset the entered value back to the captured value. The JOG/DATA dial can be used to finely adjust the entered value. You can specify the value with sub-frame accuracy by switching the Keypad Timecode Input mode to hours, minutes, seconds, frames, and sub-frames. To do this, while holding down the [SET] button, press the [LOCATE] button. Repeat this procedure to switch the Keypad Timecode Input mode back to hours, minutes, and seconds. 2 Press the [ENTER] button to fix the entered value. Alternatively, press the [LOCATE] button to locate the specified position straightaway. 3 Press the [LOCATE] button to locate the specified position. The specified position is located. In the following example, the position 00:03:00 is located. 00:00:00 Current position 00:03:00 3 0/- ENTER LOCATE x2 D24-Owner's Manual