Yamaha D24 Owner's Manual - Page 19

Display 11 C Counter The main counter shows the current position in hours, minutes, seconds, and frames, (00:00:00.00), and can display the absolute (ABS) time or relative (REL) time. See "Using Absolute & Relative Zero" on page 49 for more information. The 2nd line of the message area displays time information in hours, minutes, seconds, frames, and sub-frames (00:00:00.00.0). Each sub-frame is one tenth of a frame, making 10 sub-frames per frame. Hour Min Sec fr 0 0H 0 0M 0 0S 0 0F ST OP 000000000 Hour Min Sec fr sub-fr The 2nd line is also used to display the remaining recording time. See "Checking the Time Remaining" on page 38 for more information. D READY indicators These indicators show which tracks are selected for recording. When a track is selected for recording, the corresponding READY indicator flashes. During recording or rehearsal, the corresponding indicator lights up continuously. See "Recording" on page 33 for more information. E Message area The message area consists of two lines that can each display up to 12 characters, which typically show the status and operating mode of the D24, function and parameter names and values, project titles and numbers, locate memory numbers, editing information, time values, and so on. F LOCK indicator This indicator shows whether or not the D24 is locked to the selected wordclock source. See "Selecting a Wordclock Source" on page 124 for more information. G CHASE indicator This indicator shows whether or not the D24 is synchronized to the external timecode source. It flashes when the D24 is chasing, and lights up continuously when it's fully synchronized. See "Chasing External Timecode" on page 138 for more information. H WC window This window shows the selected wordclock source: internal (INT) or external (EXT). See "Selecting a Wordclock Source" on page 124 for more information. I BIT window This window shows the selected recording resolution: 16, 20, or 24. See "Setting the Recording Resolution" on page 32 for more information. J FS window This window shows the selected sampling rate: 44.1 kHz, 48 kHz, 88.2 kHz, or 96 kHz. When 88.2 kHz is selected, both the 44.1 kHz and 96 kHz indicators light up. See "Selecting a Wordclock Source" on page 124 for more information. The "VARI" indicator lights up when the Varispeed function is turned on. See "Using Varispeed" on page 55 for more information. K TC window This window shows the selected timecode source: master or slave. When set to master, the D24 uses internal timecode, and when set to slave, an external timecode source. See "Selecting a Timecode Source" on page 135 for more information. D24-Owner's Manual