Yamaha D24 Owner's Manual - Page 108
Erasing Parts
View all Yamaha D24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
104 Chapter 10-Editing Parts Erasing Parts The Part Erase function is used to erase part of a track. The erased part is left empty. The following points, which can be adjusted in sub-frame steps, can be selected when specifying edit points: LAST REC IN, LAST REC OUT, A, B, or a locate memory from 1 through 99. Note that you must set these points before entering the Part Erase function. See the Quick Locate Chapter on page 57 for more information about setting these points. 1 Press the [EDIT] button. The EDIT indicator lights up. 2 Use the JOG/DATA dial to select "PART EDIT," and then press the [ENTER] button. 3 Use the JOG/DATA dial to select "ERASE," and then press the [ENTER] button. "PART ERASE-TR nn" appears on the display ("nn" being the number of the track from which the part is to be erased). 4 Use the JOG/DATA dial to select the track. You can select individual tracks, track pairs, or all tracks: 1-8, 1/2-7/8, or ALL. To erase part of a virtual track, assign it to a main track first, and then erase. 5 Press the [ENTER] button. "ERS TR nn-ST MARK IN" appears on the display ("nn" being the number of the selected track and "ST" being the start point of the part to be erased). 6 Use the JOG/DATA dial to select one of the following points: MARK IN, MARK OUT, MARK A, MARK B, or a locate memory from 1 through 99. 7 Press the [ENTER] button. "ERS TR nn-ST 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the position of the selected point). 8 Use the JOG/DATA dial or keypad to adjust the start position, and then press the [ENTER] button. "ERS TR nn-ED MARK IN" appears on the display ("ED" being the end point of the part to be erased). 9 Use the JOG/DATA dial to select one of the following points: MARK IN, MARK OUT, MARK A, MARK B, or a locate memory from 1 through 99. 10 Press the [ENTER] button. If the duration of the specified part is less than 15 milliseconds, the minimum size, the message "TOO SHORT" appears. "ERS TR nn-ED 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the position of the selected point). 11 Use the JOG/DATA dial or keypad to adjust the end position, and then press the [ENTER] button. "EDIT ERASE-ARE YOU SURE" appears on the display. D24-Owner's Manual