Yamaha D24 Owner's Manual - Page 137
Selecting a Timecode Source
View all Yamaha D24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Selecting a Timecode Source 135 Selecting a Timecode Source The timecode source is selected using the TC Select function. Settings other than MASTER are used when the D24 is synchronized to external timecode. In addition to selecting the source, you must also set the frame rate. See "Setting the Timecode Frame Rate" on page 136 for more information. The TC Select setting is not stored with each project. See "About Projects" on page 30 for more information. 1 Press the [SETUP] button. The SETUP indicator lights up. 2 Use the JOG/DATA dial to select "TC SELECT," and then press the [ENTER] button. The currently selected timecode source appears on the display. 3 Use the JOG/DATA dial to select a timecode source. The following timecode sources can be selected: Source Description MASTER Internal SMPTE/EBU timecode (default setting). TIME CODE IN MIDI IN REMOTE IN SERIAL IN TC IN+VIDEO External SMPTE/EBU timecode via the TIME CODE IN. Used when synchronizing the D24 to external timecode. External MTC timecode via the MIDI IN port. Used when synchronizing the D24 to external timecode. External SMPTE/EBU timecode via the REMOTE IN/SYNC IN. Used when synchronizing slave D24s to the timecode from the master D24 in a multiple unit system. External SMPTE/EBU timecode via the TIME CODE IN and command information via the SERIAL I/O port. Used when synchronizing the D24 to external timecode and controlling via command information received at the SERIAL I/O port. External SMPTE/EBU timecode via the TIME CODE IN and video sync via the VIDEO INPUT. Used when synchronizing the D24 to external timecode and video sync. 4 Press the [ENTER] button to activate your selection, or the [CANCEL] button to cancel the TC Select function. When the timecode source is set to MASTER, "MASTER" appears in the TC window on the display, and when it's set to TIME CODE IN, MIDI IN, REMOTE IN, or SERIAL IN, "SLAVE" appears, as shown here. TC MASTER TC SLAVE 5 Press the [SETUP] button again to leave setup. The SETUP indicator goes out. When the timecode source is set to REMOTE IN, the wordclock source is also set to REMOTE IN (the EXT indicator in the WC window lights up) and the D24 is automatically configured as a wordclock slave. When the timecode source is set to a different source, the wordclock source reverts to its previous setting. D24-Owner's Manual