Yamaha D24 Owner's Manual - Page 121
MARK IN, MARK OUT, LOC MEM 01, Input & Output
View all Yamaha D24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Pitch Change 117 9 Press the [ENTER] button. "PITCH CHANGE-ST MARK IN" appears on the display ("ST" being the start point of the part to be pitched). 10 Use the JOG/DATA dial to select one of the following points: MARK IN-LAST REC IN point MARK OUT-LAST REC OUT point MARK A-A point MARK B-B point LOC MEM 01-99-a locate memory from 1 through 99 11 Press the [ENTER] button. "PITCH CHANGE-ST 00:00:00.00.0" appears on the display ("00:00:00.00.0" being the position of the selected point). 12 Use the JOG/DATA dial or keypad to adjust the start position, and then press the [ENTER] button. "PLAY OK-ENTER TO PLY" appears on the display. 13 Press the [ENTER] button to audition the source track. "PCHG PLAY-ENTER TO STP" appears on the display and playback begins at the specified start point and continues to the end of the project. Auditioning the Pitch Change function requires a lot of processing power, so for monitoring purposes only, the source tracks are mixed to tracks 7 and 8, with odd-numbered tracks appearing on the output and meter of track 7, and even-numbered tracks appearing on the output and meter of track 8. This mix can also be monitored via the PHONES, or if the Coaxial I/O is assigned to tracks 7 and 8 (see "Assigning the Coaxial Input & Output" on page 188), the COAXIAL STEREO DIGITAL OUTPUT. Track outputs 1 through 6 do not output anything when these functions are used. 14 Press the [ENTER] button to stop playback. Use the [ENTER] button to audition the source track again. 15 Press the [CANCEL] button several times to return to the mode selection display. "MODE-TEST PLAY" appears on the display, and from here you can select either "TEST PLAY" or "REC." The following illustration shows the procedure for auditioning. ST point 00:01:00.00 From TR: 2 ENTER Audition ENTER D24-Owner's Manual