1997 Chevrolet Lumina Owner's Manual - Page 280

Using Foam-Type Cleaner on Fabric 1. Vacuum and brush the area to remove loose dirt. any Ushg Solvent-Qpe Cleaner on Fabric First, seeif you have to use solvent-type cleaner at all. Some spots and stains will cleanbetter with @ off s t water and mild soap. 2, Always clean a whole trim panel or section. Mask surrounding trim along stitch or welt lines. 3. Mix Multi-Purpose Powdered Cleaner following the directions on the container label. 4. Use suds only and apply with a clean sponge. Don't saturate the material don't rub it roughly. and 5. As soon as you've clemed the section, use sponge a to remove the suds. 6. Rinse the section with clean, wet sponge. a 7. Wipe off what's left with a slightly damp paper towel or cloth. 8. Dry it immediately with a blow dryer. 9. Wipe with a clean cloth. If you need to use a solvent: 1. Gently scrape excess soil from.the ti material with rm a clean,dull knife or scraper. 2. Use very little cleaner, light pressure and clean cloths (preferably cheesecloth). Cleaning shauld start at the outside of the stain, "feathering" toward the center. 3. Keep changingto a clean section the cloth. of 4. When you clean a stain from fabric, immediately dry a the areawith a blow dryer to help prevent cleaning ring. 6-48