3M MP220 Operation Guide - Page 42
Remove Protective Film, Using the Remote, Replacing the Remote Battery
View all 3M MP220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
3M™ Pocket Projector MP220 Remove Protective Film Before you can begin using the battery, you must remove the protective film from the battery compartment. Remove the film as shown below. Using the Remote When using the remote control, point the remote control's infrared transmitter at the receiver on the projector. The receiver is beside volume up button. Note: Sun light and some indoor lighting may reduce the range of the remote control. Replacing the Remote Battery Replace the battery in the remote control with a CR2025 battery. 1 Remove the battery and battery tray by holding latch toward the center of the tray and then pull the tray out of the remote control. latch 2 Place the new battery into the tray and orientating the battery positive size (+) as indicated on the tray. 3 Finally Slide the tray into the remote Control. 42 © 2012 3M. All Rights Reserved.