Brother International BAS-416A Instruction Manual - English - Page 22
Procedures
View all Brother International BAS-416A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
• BES-1210AC 94) Y64. 44 ...;. ... . Procedures 1. Pass the upper thread from the cotton stand through the hole of the thread guide right above each cotton stand bar from the lower side. 2. Pass the thread under the thread guide tension disk by lifting it with a finger, and then wind it onto the pulley twice. 3. Pass the thread through the hole of the upper thread guide (U), wind it into the tension disk clockwise once, and place it on the spring. 4. Pass the thread through each hole of the upper thread guide (U) and the thread guide (C). 5. After passing the thread through the hole of the thread guide (U), insert the thread into the right side of the inner thread guide, and pass it through the hole of the thread take-up. 6. Bring the thread to the inner thread guide again to insert it into the hole from the upper section, then into the lower thread guide. 7. Pass the thread through the hole of the needle bar thread guide, then pass it through the needle eye, without passing it through the presser foot. 12 BAS-416A • BES-1210AC