Brother International Entrepreneur PR-650 Users Manual - English - Page 107
If the Thread Breaks or the Bobbin Thread Runs Out, While Embroidering
View all Brother International Entrepreneur PR-650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering If the thread breaks or the bobbin thread runs out while embroidering, the machine will automatically stop. Since some stitches may be sewn with only one thread, go back through the stitching to a point where stitches have already been sewn before continuing embroidering. Note ● If the thread sensor is turned off, the machine does not stop until embroidering is finished. Normally, the thread sensor should be turned on. Refer to page 204. ● Be careful when going back or forward through the stitching since the embroidery frame moves at the same time. If the upper thread breaks Re-thread the upper thread. (Refer to 1 page 55.) Touch . 2 1 2 3 1 Each touch of this key moves one stitch back through the stitching. 2 Each touch of this key moves ten stitches back through the stitching. The embroidery frame moves. Go back to the point where stitches have already been sewn. X The stitch navigating screen appears. Touch and to go back 3 through the stitching to a point where stitches have already been sewn. If the needle bar is moved back too far through the stitching, touch or to go forward through the stitching. 1 2 1 Each touch of this key moves one stitch forward through the stitching. 2 Each touch of this key moves ten stitches forward through the stitching. If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering 105