Brother International Entrepreneur PR-650 Users Manual - English - Page 233
Adjust the size of the mounting jig according
View all Brother International Entrepreneur PR-650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
Securely clamp the mounting bracket onto 4 the mounting surface by tightening the thumb screw. Adjust the size of the mounting jig according 6 to the type of cap being embroidered. 1 Mounting bracket 2 Mounting surface 3 Tighten thumb screw Memo ● If there is a gap between the clamping pad of the thumb screw and the mounting surface, insert the included pad as shown below. 1 Low Profile (Low fitting) 2 Standard type (Pro style) ■ For the standard type Using a Phillips screwdriver, turn the four screws (two on the left and two on the right) at the inside of the mounting jig one turn to loosen them. 1 Mounting bracket 2 Mounting surface (worktable, desk, etc.) 3 Pad 4 Thumb screw Check that there is no looseness. 5 If there is looseness, mount the mounting jig onto the mounting surface again. Note ● Be sure that the mounting bracket is securely clamped onto the mounting surface and that the thumb screw is firmly tightened. ● Do not attach the mounting jig to an unstable surface (flexible, bent or warped). ● Be careful that the mounting jig does not fall when it is removed. 1 Screws 2 Phillips screwdriver Note ● Do not remove any of the four screws (two on the left and two on the right); otherwise, they may be lost. Only turn the screws to slightly loosen them. 7 Using the Optional Cap Frame 231