Brother International Entrepreneur PR-650 Users Manual - English - Page 263

Error messages If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is performed, the machine stops and informs you of the error with a buzzer and an error message. If an error message appears, correct the problem according to the instructions in the message. To close the message, touch or perform the correct operation, then touch appears again, consult your nearest authorized dealer. . If the message Some malfunction occurred. There are too many characters in The installed embroidery frame is the curved text arrangement for too small. the selected embroidery frame. Check which embroidery frames Change the text arrangement or the can be used, and then install a embroidery frame. larger embroidery frame. (Refer to page 47.) The upper thread broke, the The bobbin thread broke or ran The patterns you are editing take thread came out of the thread out. up too much memory, or you are tension disc or a thread guide, or Check that there is thread on the editing too many patterns for the the machine is not threaded bobbin and that approximately 50 memory. correctly. mm (2 inches) of thread has been Check that the thread passes under pulled out, and then re-install the the upper and middle thread bobbin. (Refer to page 36.) guides, and correctly thread the upper thread. (Refer to page 55.) If the thread is not broken, clean the thread guides and the tension unit. (Refer to page 248.) 7 Troubleshooting 261