Brother International Entrepreneur PR-650 Users Manual - English - Page 52

EMBROIDERING TUTORIAL Move the left arm to align the screw on the 2 right side with the mark for the embroidery frame to be installed, and then tighten the thumb screws. For this example, align with mark 5. Hold the embroidery frame level, and then 3 simultaneously align both the left and right mounts with the embroidery frame holder clips. 1 Mark for extra-large embroidery frame 2 Mark for large embroidery frame 3 Mark for medium embroidery frame 4 Mark for embroidery frame for industrial embroidery machines* 5 Mark for small embroidery frame 6 Align the screw with the mark. * When using embroidery frames for industrial embroidery machines, the machine does not recognize the embroidery area of the frame. Be sure to use the trial sewing function to check that the pattern fits within the embroidery area. If an embroidery frame for an industrial embroidery machine is installed, the right arm of the embroidery frame holder must also move. For details, refer to page 224. Note ● Please firmly tighten the two thumb screws with included disc-shaped screwdriver. The machine will recognize the wrong frame size, if the two screws are not tightened. X The embroidery frame holder is ready for the embroidery frame to be attached. • The inner frame should be on top. Note ● If the outer frame is on top, as shown below, the embroidery frame is incorrectly attached. Insert the embroidery frame until it snaps 4 into place. 1 Make sure that the pins on the left and right arms of the embroidery frame holder fit into the positioning slot and hole on the embroidery frame. 50