Brother International Entrepreneur PR-650 Users Manual - English - Page 133

Memo Touch for the multicolor steps to 3 become shaded and the selected pattern will ● Temporary needle bar setting only applies embroider in a single color, instead of until the next color change. If the pattern changing the thread while embroidering. contains another area with the same color or when the same pattern is sewn the next time, the area is sewn with the original color. ● The thread color (needle bar) can be changed with this procedure even when the machine has been stopped with a specified pause or at the time of spool change. ● If the start/stop button was pressed to stop the machine while an area was being sewn, a temporary needle bar setting cannot be applied. The thread color X The thread color displayed on the screen will be grayed out. (needle bar) cannot be changed in the middle of an area that is being sewn. Memo ● If you touch any key of the needle bar number above, the temporary needle bar Uninterrupted embroidering (using a single color) setting will be activated. (Refer to page 130.) A selected pattern can be stitched out in one color • Touch again to return to the 4 instead of multicolor. The machine will hesitate but not stop between color steps, and then continue till pattern's original settings. the pattern is completed. Touch . Touch the key for the needle bar threaded 4 1 with the thread you wish to embroider uninterruptedly. Touch . 2 X The temporary needle bar setting screen appears. Memo ● Even if uninterrupted embroidering has been set, the DST thread trimming function can be used (refer to page 199). ● You can select the needle bar on the embroidering screen, even after touching in step 4. ● After finishing the embroidery, uninterrupted embroidery will be canceled. Temporary Needle Bar Setting 131