Brother International FAX 275 Service Manual - Page 50

1.6 Scanner Frame ASSY (1) Be sure to swing the recording head release lever (blue lever) down to the front position. (2) Remove the two screws. (3) Slightly lift up the rear edge of the scanner frame ASSY and disconnect the following five harnesses from the main PCB: • Cutter home position (HP) sensor harness (2-pin) • CIS harness (7-pin) • Recording head harness (12-pin) • Solenoid harness (2-pin) • Motor harness (6-pin) (4) Lift up the scanner frame ASSY from the rear and take it out from the main frame. NOTE: Do not hold the lower paper chute but the upper paper chute. The lower paper chute is easily deformed. FAX255/FAX275/FAX-515/1-1OIVIEFAX3 Upper paper chute (Hold here.) Wrong handling Scanner frame ASSY Lower paper chute (Do not hold here.) Main frame IC (NCU connector) ACS grounding spring I L P1 O Cutter HP sensor harness (2-pin) P2 SW3 SW2 P7 CIS harness (7-pin) P3 PH1 El P5 E El PH2 [L_ P10 1 Pb P8 SW1 P4 Recording head harness (12-pin) Main PCB Solenoid harness (2-pin) Motor harness (6-pin) IV - 14