Brother International FAX 275 Service Manual - Page 52
electrolytic
UPC - 012502564546
View all Brother International FAX 275 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
(5) Lift up the ACS grounding spring. • Reassembling Notes • Before putting the scanner frame ASSY back onto the main frame, be sure to set the ACS grounding spring as illustrated on the previous page. • Make sure that tabs "A" of the scanner frame ASSY are fitted in cutouts "B" provided in the main frame. (See the illustration on the previous page.) • For the FAX355MC/FAX375MC/FAX-525DT/FAX-525MC: After putting the scanner frame ASSY back onto the main frame, route the harnesses and arrange the cores as follows, referring to the illustration below. - Hook the power supply harness core on boss "C." - Check that the cutter HP sensor harness runs through a core, and then hook the core on boss "D." - Push the CIS harness core and the recording head harness core into position, to the left of rib "E" and behind relay "F." - Route all these harnesses under boss "D." If any of these harnesses and cores are out of the specified position, the scanner frame ASSY or ROM cover may not be put back into place. • For the FAX355MC/FAX375MC/FAX-525DT/FAX-525MC: After connecting these harnesses, check that neither the electrolytic capacitor nor resistors are tilted towards the PE sensor actuator. If tilted, they may interfere with normal operation of the sensor actuator. Boss "C" Power supply harness (Rear) Cutter HP sensor harness L Motor harness .11 Main PCB CIS harness Electrolytic ll capacitor Boss "D" Relay "F"Rib Resistors Solenoid harness Recording PE sensor actuator head harness (FAX355MC/FAX375MC/FAX-525DT/FAX-525MC)