Brother International PJ623 PocketJet 6 Plus Print Engine User Guide - Page 25

Setting Printer Driver Options 2 When printing from a computer program, various printing options can be selected using the printer driver. Paper Type 2 Available settings: [Cut Sheet], [Roll], [Perforated Roll], [Perforated Roll Retract] Default setting: [Cut Sheet] Set this option to match the type of paper that is loaded. For Mac OS® users, see Selecting Paper Type on page 23. Density 2 Available settings: [0] - [10] Default setting: [6] (PJ-623/663), [4] (PJ622/662) This option determines print density, which affects the darkness of the printed document. A lower value produces lighter print; a higher value produces darker print. Darker print uses more battery power, but may be easier to read if the font or other document content is made up of narrow lines. If battery conservation is important, select a lower value. 2-ply Mode 2 Available settings: [Disable], [Enable] Default setting: [Disable] This option is used when 2-ply paper is loaded. When [Enable] is selected, the printer produces prints that are darker (and print slower) than when [Density] is set to 10. Using the Printer Form Feed Mode 2 Available settings: [No Feed], [Fixed Page], [End of Page], [End of Page Retract] Default setting: [Fixed Page] 2 This option determines how paper is ejected; it determines how the printer responds to form feed command.  No Feed - Paper is not fed at the end of a job. Because additional paper is not ejected when at the end of the document, this setting is useful when using non-perforated roll paper.  Fixed Page - Paper is fed at the end of a job to suit the vertical length of the selected page size (i.e., letter, legal, A4, or user-defined size). Select this setting when using cut sheet paper.  End of Page - Paper is fed until the printer detects that no paper remains in the input slot, or until 14" (355.6 mm) of paper has been fed. Select this setting when using perforated paper.  End of Page Retract - Paper is fed until the paper sensor detects a pre-printed end-of-page mark on the paper or the end of the sheet. When this setting is selected, set [Paper Type] to [Perforated Roll Retract]. No Feed Mode Extra Feed 2 Available settings: [None], [1/2 inch (12.7 mm)], [1 inch (25.4 mm)], [1-1/2 inches (38.1 mm)], [2 inches (50.8 mm)] Default setting: [1 inch (25.4 mm)] This option is used when [Form Feed Mode] is set to [No Feed]. Paper is ejected after the last page of the document according to the setting. 21