Canon REALiS LCOS WUX5800 WUX7500 WUX6700 WUX5800 Users Manual - Page 173
Lamp counter, Air filter counter, Power counter, Firmware
View all Canon REALiS LCOS WUX5800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 173 highlights
Menu Description Lamp counter You can reset the lamp counter that indicates the time for lamp replacement. For details on lamp counter display, see "Replacing the Lamp" (P210). • Do not reset the lamp counter except when you have replaced the lamp. Otherwise, the lamp counter cannot indicate the correct timing for replacing the lamp. • Lamps are more likely to rupture once the lamp replacement message has been displayed (P210). Replace the lamp with a new one as soon as possible. • The lamp counter provides an estimate of the time remaining until the lamp must be replaced. This value is based on the hours in use and the present load on the lamp. • The number of hours indicated is equivalent to use under these conditions: [Lamp mode] (P141) set to [Full power]. Air filter counter Shows a counter to remind you when to replace the air filter. Also shows a counter reset screen. • After air filter replacement, reset the air filter counter. • For details on replacing the air filter, see P207 - P209. Power counter Indicates the total time that the projector has been connected to a power supply. This value is not reset even if [Factory defaults] is executed. Firmware Update the projector firmware. Check the version indicated before updating the firmware. Update the projector firmware as follows. 1. Download updated firmware from the Canon website and store it at the root directory on a USB flash drive. 2. Insert the USB flash drive in the USB port. 3. Follow the instructions shown to complete the update process. • Firmware versions shown here are for illustration only and differ from actual versions. • In some cases, it may not be possible to download updates. For details, contact the Canon Customer Support Center. • Firmware updating takes a few minutes. During the update, the LED indicator will flash in red. Do not turn off the projector while the LED is flashing. After the update, the projector will automatically turn itself off and enter standby mode. 171 Menu Guide Menu Description