Canon REALiS LCOS WUX5800 WUX7500 WUX6700 WUX5800 Users Manual - Page 50

Projection Procedure ■ Projecting an Image in the DICOM SIM Mode In the DICOM simulation mode (hereinafter referred to as "DICOM SIM"), this projector can project a monochrome medical image such as an X ray radiography, CT image, MRI image, etc. in the tone similar to the DICOM (Digital Imaging and Communications in Medicine) standard. Typically, to project the image according to the DICOM standard, it requires the grayscale tone correction using a luminance meter according to the environment. In this projector, there are 21 types of tone settings for various ambient lights. You can correct the tone in a simplified manner by selecting the DICOM test pattern (P105). It is suited to project an image in a medical lecture, academic conference, inhospital conference, etc. This projector is not the display monitor for a medical image. It cannot be used for the radiological image reading or medical examination. • It is recommended to check the tone everytime when using this projector since it does not have the tone correction and calibration functions against the secular change. • It may take approximately 30 minutes until the projection brightness of this projector becomes stabled. Switching the mode to the DICOM SIM Mode 1 Press the IMAGE button on the remote control until [DICOM SIM] is displayed or select [DICOM SIM] from [Image mode] in the [Image adjustment] menu. 2 Display test patterns by pressing the TEST PATTERN button on the remote control or selecting [On] in [Test pattern] of the [Install settings] menu. Press the [ ] / [ ] buttons to select the DICOM test pattern. 48