Canon REALiS WX6000 Pro AV User Manual - Page 175

Network Settings on the Projector Turning DHCP Function On / Off You can turn the projector DHCP function on or off. MENU > [Network Setting] > [DHCP] TCP / IP Setting Configure the projector TCP / IP settings. MENU > [Network Setting] > [TCP/IP setting] Installation Manual Connecting to a Network Off Disables the DHCP function. TCP / IP settings are possible. On Enables the DHCP function. Searches the DHCP server. Because the IP address is acquired from the DHCP server, it is not necessary to enter the TCP / IP settings (IP address, subnet mask, gateway address). Press the OK button to accept your setting and then press the MENU button or EXIT button (WX6000 / SX6000). • [Off] is the factory default. When [TCP/IP setting] is selected, the window shown below appears. Use the [ ] / [ ] buttons to select the IP address, then press the OK button. Next, use the [ ] / [ ] buttons to select the digit and the [ ] / [ ] buttons to change the value. For the WX6000 / SX6000, numbers can be entered using the numerical buttons on the remote control. Press the OK button, then set the subnet mask and gateway address in the same way. Finally, select [Enter]. • The factory defaults are shown below. IP address 192.168.254.254 Subnet mask 255.255.255.0 Gateway address 0.0.0.0 • Settings cannot be made when [DHCP] (P175) is [On]. • If an invalid value is entered, the message "Invalid entry" appears. If this occurs, enter a valid value. 175