Canon REALiS WX6000 Pro AV User Manual - Page 194

Cleaning and Replacing the Air Filter 5 Securely insert the air filter all the way into the projector. • Handle the air filter carefully. If damaged, the air filter will not work properly. • When the lamp is replaced, it is recommend that you also replace the air filter. • Contact the Canon Customer Support Center for further information. • Replacement air filter part No.: RS-FL01 • This can also be purchased from the Canon home page (http://store.canon.jp/user/ListProducts/list?svid=2&sc=LMPPR&jsp=/jsp/search/ search_item_acc.jsp). Cleaning the Air Filter The air filter protects the lens and mirror inside the projector from dust and dirt. Should the air filter become clogged with dust, the projector may be damaged since it will block the air flow into the projector and raise the internal temperature of the projector. The following screen is displayed when turning on the projector if the air filter needs to be cleaned (after approx. 300 hours). Clean the air filter if it is displayed. • Only the [ ], [ ], OK and POWER buttons are available while this screen is displayed. (When you press the POWER button, the message "Push POWER button again to turn off power" appears.) • When this screen has disappeared after being displayed for 10 seconds, all buttons become operable. • Turn the power of the projector off and pull out the power plug. • Hook your finger into the air filter handle on the side of the projector, and remove the air filter. Then use a vacuum cleaner to remove the dust. • If the filter replacement screen is displayed when turning on the projector after cleaning the air filter, select [Yes] and press OK. The filter replacement screen will disappear. • This screen is not displayed when [Filter warning display] is set to [Off]. (WX6000 / SX6000) (P137) 194