Canon S630 Network S630 Quick Start Guide - Page 12

To load envelopes

Get Canon S630 Network PDF manuals and user guides View all Canon S630 Network manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Basic Printing To load envelopes: 1. Lift the cover and set the paper thickness lever to the envelope mark. Close the cover. 2. Slide the paper feed guide to the left. 3. Press down on the corners and sides of the envelopes to make them as flat as possible by expelling all of the air. To avoid paper jams, make sure envelopes are flat before you load them into the paper tray. Make sure that none of the flaps overlap. If the envelope edges are not flat, crease them with the side of a pen. Do not allow more than 10 envelopes to stack on the paper output tray. 4. With the address side facing up and pointed in the direction shown in the illustration, align the stack with the right side of the paper rest, then insert the stack into the printer. 5. Slide the paper guide to the edge of the envelopes until it is firmly in place. Flap side of envelope faces down 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
6
Basic Printing
To load envelopes:
1.
Lift the cover and set the paper thickness lever to the envelope mark. Close
the cover.
2.
Slide the paper feed guide to the left.
3.
Press down on the corners and sides
of the envelopes to make them as flat
as possible by expelling all of the air.
To avoid paper jams, make sure
envelopes are flat before you load
them into the paper tray.
4.
With the address side facing up and
pointed in the direction shown in the
illustration, align the stack with the
right side of the paper rest, then
insert the stack into the printer.
5.
Slide the paper guide to the edge of
the envelopes until it is firmly in place.
Make sure that none of the flaps overlap. If the envelope edges
are not flat, crease them with the side of a pen.
Do not allow more than 10 envelopes to stack on the paper
output tray.
Flap side of envelope faces down