Canon iP4600 User Manual - Page 364

Error Message Appears on a PictBridge Compliant Device Стр. 364 из 396 стр. Advanced Guide > Troubleshooting > Error Message Appears on a PictBridge Compliant Device Error Message Appears on a PictBridge Compliant Device The following are the possible errors that may occur when printing directly from a PictBridge compliant device and the countermeasures to clear them. Note This section describes errors that are indicated on Canon-brand PictBridge compliant devices. The error messages and operations may vary depending on the device you are using. For errors on non -Canon PictBridge compliant devices, check the status of the Alarm lamp and take the appropriate action to clear the error. For details, see Alarm Lamp Flashes Orange . For the errors indicated on the PictBridge compliant device and their solution, also refer to the instruction manual of the device. For other troubles on the device, contact the manufacturer. Error Message On PictBridge Compliant Device "Printer in use" "No paper" "Paper Error" "Paper jam" "Printer cover open" "No print head" "Waste tank full"/"Ink absorber full" "No ink"/ "Ink cassette error" "Ink Error" "Hardware Error" "Printer error" Action If the printer is printing from the computer or warming up, wait until the job ends. When it is ready, the printer starts printing automatically. Load paper, and select Continue* in the display on your PictBridge compliant device. * To resume printing, you can also press the RESUME/CANCEL button on the printer instead of selecting Continue on the device. If the Paper Output Tray is closed, open it. The printer resumes printing. If the Inner Cover is opened, close it and select Stop in the display on your PictBridge compliant device to stop printing. Select Stop in the display on your PictBridge compliant device to stop printing. Remove the jammed paper, load new paper, press the RESUME/CANCEL button on the printer, then try printing again. Close the Top Cover on the printer. The Print Head is defective or is not installed. See Five flashes: in Alarm Lamp Flashes Orange and take the appropriate action. The ink absorber is nearly full. See Eight flashes: in Alarm Lamp Flashes Orange and take the appropriate action. The ink tank is not installed properly or empty. Check the number of how many the Alarm lamp flashes and take the appropriate action to resolve the error. Alarm Lamp Flashes Orange An ink tank that was once empty is installed. See Thirteen flashes: in Alarm Lamp Flashes Orange and take the appropriate action. Ink tank errors have occurred. Replace the ink tank. Routine Maintenance An error requiring servicing may have occurred. (The Power lamp flashes green and Alarm lamp flashes orange alternately.) Power Lamp Flashes Green and Alarm Lamp Flashes Orange Alternately Disconnect the USB cable between the printer and the