Canon imagePROGRAF TX-4100 MFP Z36 imagePROGRAF TX-4100 TX-3100 TX-2100 TX-541 - Page 765

Paper is not cut straight Check 1 Is the edge of the paper cutting position creased? Straighten out any curling by the edges of the paper. Check 2 Is the edge of the paper cutting position lifting up when cutting? Reload the paper correctly. Check 3 Is the paper a type that can be cut with the cutter blade? Set Cutting mode in the touch screen menu to User cut, then and cut the roll paper with a cutting implement such as scissors. Specifying the Cutting Method for Rolls Check 4 Are you using the basket properly? Make sure that you are using the basket properly. Using the Basket Check 5 Are you using the stacker properly? Make sure that you are using the stacker properly. Using the Stacker Check 6 Check that the Cut speed setting is correct. Tap paper settings display area on Home screen of touch screen, tap the feed slot where the paper to change is set, then tap Paper settings > Advanced and, change the setting value of Cut speed. If the paper edge cannot be cut straight at the cut starting position, it may be improved by selecting slower cut speed than that selected currently. If the paper edge cannot be cut straight at the cut ending position, it may be improved by selecting faster cut speed than that selected currently. Check 7 Did the printing material slip diagonally while being cut? Set the Cutting mode in the touch screen menu to Eject cut, and then hold and cut the material after it has printed. Specifying the Cutting Method for Rolls Check 8 Is the cutter blade attached properly? Attach the cutter blade properly. 765